Which command-line option configures takeover partner address on an interface?

Which command-line option configures takeover partner address on an interface?

• A. ipconfig interface partner address
• B. ifconfig partner address
• C. ifconfig interface partner address
• D. netconfig interface partner address

Answer: (C)

To set the takeover partner address for a specific interface in NetApp 7-Mode, you use the ifconfig command with the interface name followed by the keywords partner address and the IP. The correct form is: ifconfig <interface> partner address <ip-address>. This binds the takeover partner address to that particular interface, which is what the HA pair uses to coordinate failover. Other commands don’t fit this task: using ipconfig doesn’t apply to configuring the takeover partner for an interface, and omitting the interface would leave the operation ambiguous. netconfig is not the syntax for setting a partner address on an interface.

To set the takeover partner address for a specific interface in NetApp 7-Mode, you use the ifconfig command with the interface name followed by the keywords partner address and the IP. The correct form is: ifconfig partner address . This binds the takeover partner address to that particular interface, which is what the HA pair uses to coordinate failover.

Other commands don’t fit this task: using ipconfig doesn’t apply to configuring the takeover partner for an interface, and omitting the interface would leave the operation ambiguous. netconfig is not the syntax for setting a partner address on an interface.